Ultra-Flexible Removable Magnetic Build Platform

Description

Product details:

1.Product size: 220mm x220mm/8.7inch x 8.7inches.

2.Backing: B side with 3M adhesive.

3.Easy to use: Level the printing platform first, and Keep the nozzle and the printing platform within a minimum of 0.1mm.

4.Do not let heated nozzle touch the A plate directly differently it’s going to damage the surface layer.

5.Because of the special material of this magnetic surface , the temperature of the hot bed will have to not be higher than 70 degrees, or non-heated bed printing.

Make sure this fits by entering your model number.
COMPATIBLE PRINTERS】: The Flexible Removable 3D Printer Platforms in 220mmx220mm (8.7″ x 8.7″) size will fit Anet A8, Anet A6, Reprap Prusa i3, MK2, MK2A and suitable for all FDM printer models, as well as all heated and unheated 3D printer beds. This magnetic bed replacement can be easily cut to any size.
【UNIQUE COORDINATE DESIGN】: The design of built-in Coordinates make you’ll easy to measure size or fix the printing positioning. If you do not need to adding the coordinate sheet on top of the hot bed then our build-in coordinate 3D printer magnetic bed is you wish to have, save your time of extra measurement.
【WIDELY USES】: Our magnetic elexible Hheated bed widely used in PLA、PETG、PEEK、ABS and other filaments. It is capable to work at 70ºC. No need any tape, glue, or shovel. Easy to adhere to the print bed, release the prints easily, flex rather to pop your print right off.
【DURABLE MATERIAL & ESAY TO USE】: This magnetic bed made of durable and premium material,it may be reused many times, and consists of A and B pieces. The 3d printer heated bed of B side has 3M adhesive already laminated to the backing side, simply tear off the protective paper and attached to the aluminum plate. Leveling the bed first then put the A side on the B, then you’ll start your 3d creation journey！
【IMPORTANT TIPS】: Please make sure the bottom of the soft magnetic adhesive is firmly attached to the upper layer before installation. If it cannot be attached, please rotate 90 degrees and check out again until it is fully attached. Do not let heated nozzle touch the A plate directly differently it’s going to damage the surface layer. Clean the surface with soft cloth or warm soap water in a few swipes.