Monoprice – Gray PLA Plus Filament

Description

Get outstanding 3D printing results when you use 1.75mm PLA Plus+ 3D Printer Filament from Monoprice! PLA Plus+ is a great choice for a printing material if you’re searching for high accuracy and high resolution. It does not require a heated base and has a very low shrinkage rate (0.3%). PLA Plus+ is stronger than bizarre PLA, possessing the same strength as normal ABS material. This 1.0kg spool features a thickness of 1.75mm ±0.10mm, with a roundness variation of only 0.03mm. It has a nominal processing temperature range of 205 ~ 225°C (401 ~ 437°F). Thickness and roundness factors are laser measured at the factory to make sure accuracy over all the length of the filament. The negatives of the usage of PLA Plus+ is that it is susceptible to degradation from moisture, sunlight, and heat. Additionally, it is more at risk of overheating all over processing, which can cause dripping and drooping if it gets too hot.

Make sure this fits by entering your model number.
PLA Plus+ is a great choice for a printing material if you’re searching for high accuracy and high resolution.
This 1.0kg spool features a thickness of 1.75mm ±0.10mm, with a roundness variation of only 0.03mm.
It has a nominal processing temperature range of 205 ~ 225°C (401 ~ 437°F).
Thickness and roundness factors are laser measured at the factory to make sure accuracy over all the length of the filament.
The negatives of the usage of PLA Plus+ is that it is susceptible to degradation from moisture, sunlight, and heat.